back to constructing my own

5 MSOP-8:


I thought I had the right breakout board for this part but it turns out the dual breakout I had was
SOT-23 on one side and SOP-10 on the other side, and this part is a MSOP-8, which is almost exactly
between those two. So I ended up carefully bending the pins and managing to solder down to the
slightly larger SOT-23 side. Took a few tries, the leads on that package work like solder wick.

I ended up using some hair-thin (solid core, no rosin) 0.35mm solder, a USB solderig pencil with
a super sharp point, and a whole lot of time looking through my AmScope microscope.



LT6105IMS8 current sensor (in datasheets and parts)


SOP10-SOT23 to DIP10 Breakout (10pcs for $7 at eBay)

1 pins bent	2 soldered	3 top row	4 bottom row	penny1	penny2
penny3	pins1	pins2	pins3	pins4	pins5
SOT23,SOP10 breakout vs MSOP-8

highest resolution images
last updated 06/17/2025 at 10:35:30 by make_www_index.command version 2025.05.20.B